How to repair a leaking gutter joint in 5 Minutes

Learn how to repair a leaking gutter joint in 5 minutes by following this step-by-step guide.

Leaking Gutter JointGutter joints can start to leak for a number of reasons. Plastic gutters expand and contract when the gutter warms up and cools down. When gutters are installed properly, the gutter joints allow for this movement. When gutters are not installed properly, the gutter can pop out from the connecting joints which will cause a gutter leak.

Extra weight in your gutters from standing water, snow and debris can sprain gutter joints causing them to leak.  in this case, the sprained gutter joint should be re-secured by attaching the joint to the fascia board before re sealing the joint.

Tools you will need:

  • Suitable Access i.e. ladder or scaffold tower
  • Wet cloth
  • Absorbent roll
  • Flat blade screwdriver
  • Replacement Joint or Gasket Seals if the existing ones are damaged.
  • Caulking Gun – see recommended
  • Good quality gutter sealer – see recommended

1. Clean out your gutters and downpipes to ensure there are no blockages. This will remove any blockages and help drain any standing water that might be present in the gutters.

2. Un-clip the gutter bracket next to the joint that needs to repair and the gutter joint that is leaking. In some cases it may be easier to remove this section of gutter.

Detach the gutter from the union joint a nearest clip

3. Remove the gutter gasket/seal that is in the union joint, a flat blade screwdriver can help with this. Inspect the gasket/seal checking it for splits or damage. New seals or complete union joints can be easily purchased on-line. Inspect the union joint, ensure the clips are not damaged and there are no cracks present.

Remove the gutter seal

4. If the gasket/seal is OK, clean it with a damp cloth to remove built up debris. If it is damaged, split or heavily corroded it would be best to repae the gaskets or the union joint.

Clean the gutter seal

5. Now clean and dry the union joint, including the gasket groove and both sides of the gutter where the union joint attaches. This will ensure that the gutter gasket will be seated properly so it forms a good seal when the gutter is attached.

Clean the gutter and gutter joint

6. Replace the gasket/seal into the grove of the union joint. (ensure it is the correct way round).

Replace the gutter seal

7. Make sure the gutter lines up with the union joint and clip the union joint and gutter brackets back onto the gutter.

Clip the gutter back onto the union joint and clips

8. To ensure the gutter does not leak again and to prevent the gutter from slipping out of the joint, you can apply a bead of good quality gutter sealant to each side of the union joint.

Apply a good quality gutter sealer

Well done! you have successfully re-sealed a leaking gutter joint. Need help or advice? We are always here to help! For any help or advise, please don’t hesitate, contact our guttering repairs team today on 0844 884 97 24.

You may also like...

Leave a Reply

Your email address will not be published. Required fields are marked *